Important Notes for TH-65PF10UK, and TH-50PF10UK:
The new Type 10 PF models now come with a digital TY-FB10HMD Dual HDMI Input
Board rather than the TY-FB9FDD DVO-D digital RGB (with HDCP) Terminal Input Board Input.
The new Type 10 PF models can display 1080/60p only through the digital TY-FB10HMD
Dual HDMI Input Board (supplied) or through the following analog interfaces: fixed PC
input (supplied), TY-42TM6A (supplied), optional TY-42TM6P, optional TY-42TM6G, optional
TY-42TM6Y, optional TY-42TM6Z. The older HDMI Board TY-FB8HM (version 1), new
TY-FB10HD HD-SDI/SDI (1.485Gb/s/270Mb/s) option with embedded audio, and the old (now
discontinued) TY-FB7HD HD-SDI/SDI (1.485Gb/s/270Mb/s) option with no embedded audio do not
support 1080/60p. The units are 1920x1080 native, however, this is for conforming PC
signals or only when 1:1 Pixel Mode is turned on with 1080p input (when not turned on,
there is an approximate 3% overscan, and 1080p is shown at about 97% size h & v,
aspect ratio of 1.77 maintained).
Certain input boards are
shipped standard with these models, and there is one open option slot: |
|
Input Option Boards Installed in
TH-65PF10UK, and TH-50PF10UK as shipped:
TY-FB10HMD Dual HDMI (with HDCP) Board Input (2 HDMI Inputs) Ships installed in Slot 2 as
shown above. HDMI supports Linear PCM audio (48/44.1/32 kHz) and HDCP. You can
purchase an additional TY-FB10HMD Board as an option and install it in Slot 1, or another
option Board (see below). This board is designed for Slot 1 or 2 (PF Series and PH
series). In the PF models, the TY-FB10HMD Dual HDMI Type A Board supports inputs of
480P/60, 625/50P, 720/50/59.94/60p, 1080/50/59.94/60i, plus 108024/25/50/60P. In the
PH models, 1080/24/25/50/60P input is not supported.
-------------------------------
TY-42TM6A BNC Component Analog Video Terminal Board Input Ships installed in Slot 3.
You can purchase an additional Board as an option and install it in Slot 1. This
board is designed for Slot 1, 2, or 3 (Series Type 6-9)
-------------------------------
Fixed (non-removeable) PC D-Sub 15-pin input female connector with audio in and D-Sub
9-pin RS232C Serial male connector (note: male for PF Series, female for PH/PS Series) |
Other Input Display Options and
notes for Series Type 10 (including older Types as noted)*
(board installation/removal may be necessary and is not included):
*(Pre-Installed boards come with the units, see photos for input boards that ship
standard)
TY-FB10HMD Dual HDMI (type A connector) Board Input (2 HDMI Inputs) HDMI supports Linear
PCM audio (48/44.1/32 kHz) and HDCP.
In Type 10 PF models: 1080/50/59.94/60p, 1080/24/25/30p
(525/59.94i, 625/50i, 720/59.94/60p, 1080/23.98/24PsF, 1080/50/59.94/60i), VGA60.
(When installed in Type 10 PH models there is no 1080p)
For Slot 1 or 2 only (PF or PH Series Type 10 ONLY)
-------------------------------
TY-FB10HD HD-SDI/SD-SDI (10-bit) Input with embedded audio support (note: for the PF type
10 models ONLY, and NO 1080/60p)
(525/59.94i, 625/50i, 720/50/59.94/60p, 1080/23.98/24PsF, 1080/24/25/30p,
1080/50/59.94/60i)
For Slot 1 or 2 only (PF Series Type 10 ONLY)
-------------------------------
TY-FB9HD HD-SDI/SD-SDI (10-bit) Input (note: NO 1080/60p, no embedded audio)
(525/59.94i, 625/50i, 720/50/59.94/60p, 1080/23.98/24PsF, 1080/24/25/30p,
1080/50/59.94/60i)
For Slot 1 or 2 only (PF Series Type 9 or 10)
1 75 oHm BNC Input with active throughput
-------------------------------
TY-FB9BD BNC Dual Analog Video (CVBS, S-Video) Terminal Board Input
For Slot 1 or 2 only (Type 9-10)
-------------------------------
TY-FB7SD - SDI Input
For Slot 1 or Slot 2 only (Series Type 7-9 recommended only)
-------------------------------
TY-FB7HD - HD-SDI Input (note: NO 1080/60p) -DISCONTINUED
For Slot 1 or Slot 2 only (Series Type 7-9)
-------------------------------
TY-FB8HM - HDMI (version 1) Input (note: NO 1080/60p in this HDMI version)
(vers. 1.1: 525/60p, 625/50p, 720/50/60p, 1080/50i/60i, VGA60)
For Slot 1 or Slot 2 only (Series Type 8-9 PH recommended only)
-------------------------------
TY-42TM6D DVI-D digital RBB (with HDCP) Terminal Board Input (note: NO 1080/60p)
For Slot 1 or Slot 2 only (PH/PS Series Type 6-9 recommended only)
-------------------------------
TY-42TM6A BNC Component Analog Video Terminal Board Input
For Slot 1, 2, or 3 (Series Type 6-10)
-------------------------------
TY-42TM6B BNC Composite Analog Video Terminal Board Input
For Slot 1, 2 only (Series Type 6-10)
-------------------------------
TY-42TM6Z RCA Component Analog Video Terminal Board Input
For Slot 1, 2, or 3 (Series Type 6-10)
-------------------------------
TY-42TM6V RCA Composite Analog Video Terminal Board Input
For Slot 1, 2 only (Series Type 6-10)
-------------------------------
TY-42TM6P PC Display Analog Terminal Board Input (does not support DPMS)
For Slot 1, 2, or 3 (Series Type 6-10)
-------------------------------
TY-42TM6G RGB Analog Active Throughput Terminal Board (Input with throughput)
For Slot 1&2 only (2 slots used) (Series Type 6-10)
-------------------------------
TY-42TM6Y Composite & BNC x 5 [Y, Pb or R, G, B, VD sync, HD sync]
For Slot 1&2, or 2&3 (2 slots used) (Series Type 6-10)
-------------------------------
Stands & Brackets:
TY-ST07-K Desktop Stand for 37-inch, 42-inch, 50-inch Only
TY-ST08-K Desktop Stand for 37-inch, 42-inch, 50-inch Only
TY-ST58-K Desktop Stand for 58-inch Only
TY-ST65-K Desktop Stand for 65-inch Only
TY-WK42PV7 Flush Wall Mount Bracket for 37-inch, 42-inch, 50-inch Only
TY-WK37PV3 Flush Wall Mount Bracket for 37-inch only
TY-WK65PV7 Flush Wall Mount Bracket for 65-inch only (Series Type 7-9)
TY-WK42PR7 Angeled Wall Mount Bracket for 37-inch, 42-inch, 50-inch Only
TY-CE42PS7 Ceiling Mount Bracket for 37-inch, 42-inch, 50-inch Only
TY-WK42DR1 Drawer-type Wall Mount Bracket for 42-inch, 50-inch Only
TY-ST42PW1 - Wall Stand for 37-inch, 42-inch, 50-inch Only
TY-ST42PF3 Mobile Floor Stand for 42-inch, 50-inch Only
TY-ST58PF10 Mobile Floor Stand for 58-inch Only
CF-PLP2051 Chief Wall Mount with Tilt capability for 37", 42", 50" Type
7&8
Speakers:
TY-SP65P10W-K (for TH-65PF10UK)
TY-SP58P10WK (for TH-58PH10UKA)
TY-SP50P8W-K (for TH-50PF9UK/50PH9UK/50PF10UK/50PH10UKA)
TY-SP42P8W-K (for TH42PH9UK/42PS9UK/42PH10UKA)
TY-SP37P8W-K (for TH-37PH9UK/37PH10UK)
Anti-Glare Filters:
TY-AR65P9W (for TH-65PF9UK/65PF10UK)
TY-AR50P9W (for TH-50PF9UK/50PH9UK/50PF10UK/50PH10UK)
TY-AR42P9W (for TH42PH9UK/42PS9UK/42PH10UK) |
Panasonic
Monitors
