VTP is a Premere Cine Alta Dealer for these products.

Broadcast & Professional
-Authorized Dealer-
< Sony Home >

J-H3

This unit is specifically designed for HDCAM and HDCAM CineAlta tape sources to perform in a limited non-synchronous non-editing playback environment, although Remote RS422A (limited) and RS232C (limited) is standard, and there is an optional IEEE standard definition output.

Down Conversion with pull-down (in 23.98PD mode standard play speed playback) is built-In.  Equipped with HD-SDI and SDI outputs (both with embedded audio).   Accomodates both small and large cassettes.  Equipped with HD analog Y/Pb/Pr component output. NTSC or PAL (system playback and tape frequency depending) composite video output from both BNC and RCA output connectors.  RGB computer display interface (at XGA 1024x768 resolution letter-boxed to 1024x577 pixels in the image center).   LTC Timecode output.  Reference Input.  TC Character Superimposing Capability.  Tele-File Handling (requires optional TeleFile label MLB-1M-100 and Optional Video Logging Software JZ-1).  V-ANC output is not supported.  Additional limitations may apply.

Down-Convert Aspect Ratios
Letterbox of 16:9, 14:9, 13:9
Edge-Crop (h crop + - 120)
Squeeze
Setup on/off for SD output

This Unit operates at 3 different base system frequency tape playback speeds, as follows:
HDCAM: 1080/29.97 Hz: 96.7mm/s (PsF or Interlace source)
HDCAM: 1080/25 Hz: 80.7mm/s (PsF or Interlace source)
HDCAM CineAlta: 1080/23.98(PD)/24 Hz: Approx. 77.4 mm/s (PsF or Interlace source)
Shuttle Mode is ±21X, Jog Mode is ±1X
Servo Lock is 1 Second or less (from Standby on)

System Frequency Select: 29.97/25/24/23.98/23.98PD.  This unit is currently capable of slewing picture playback between 23.98, 24, and 25 Hz, allowing for a PAL picture output from a 23.98 or 24 frame Master CineAlta tape (for some slew speed changes, however, there may be muted audio output, or other differences compared to the HDW-F500 studio VTR).  Any of these specifications may change without notice.

JH3 connections
Digital HD video Output with embedded audio BNC x 1, SMPTE-292M
Digital SD Video Output with embedded audio BNC x 1, SMPTE-259M**
Analog HD video Output BNC (x 3) Y: 0.7 vp-p, Pb/Pr: +/-0.7vp-p 75 oHm (to 20Mhz Luma Y)
Analog HD video Output EIAJ RC-5237 connector, EIAJ CP-4120 standard
Computer display Output D-sub 15 pin, XGA Analog (1024 x 768 dots), RGB, 0.7 V
(R: 700 mV (±5 %), G: 700 mV (±5 %), B: 700 mV (±5 %) at 60Hz, H Frequency 48.4 kHz)
(Note: HD Image is letterboxed 1024x577 at picture center)
Timecode Output BNC x 1, SMPTE 12M
Audio monitoring Output Pin jack (x 2): -10 dBu at 47 koHms load, unbalanced
Audio monitoring Output XLR (mappable, male x 2) +4 dBm, 600 oHm load, low impedance, balanced
Headphone Output JM-60 stereo phone jack, - to -12 dBu at 8 oHms, unbalanced
RS-422 D-sub 9 pin female (x 1), Sony 9-pin remote interface
RS-232C D-sub 9 pin male (x 1) (Supports optional JZ1 Sony Logging Software**)
Wireless remote BIRCS
EXT Sync Input BNC x 2 (HD TriLevel or SD BB or Composite Sync, frame locked)
i.LINK Output (Optional) IEEE1394 (See option below)

JH3 Options**
Optional: Power Cord.  HKJ101 6-pin I-Link for HD down converted to SD compressed standard definition 25Mb/s DV 4:1:1 or 4:2:0 output** with video, audio, and time code.   Output follows the playback frequency and a Pulldown Insertion Mode is available (see comments above for tape slew of 23.98/24/25 frames per second or vice versa).  Assemble or Insert editing functions can not be used to control the JH3 via the DV Link.  Tele-File Label system with JZ1 Option MLB-1M-100.  Future Options may or may not be available.

**NTSC/PAL standard definition output capable.  Note: NTSC is only capable from standard play speed of 1080/23.98 (23.98PD system frequency) with pull down added based on 24F TC A-FRAME SELECT, or 1080/29.97 playback, and PAL is only capable from 1080/25 (50i) Hz. The Unit also supports the Optional Sony Tele-File Label system with JZ1 Option MLB-1M-100.  Future Options may or may not be available. Any of these specifications may change without notice.

Standard Accessories
Operation manual (CD-ROM), Quick operation guide, Vertical stand (x 2), Infra-red remote controller.  Power Cord is not included. Any of these specifications may change without notice.

J-H1

This unit is specifically designed to provide analog HD output from HDCAM source tapes and perform in a limited non-synchronous non-editing playback environment, although Remote RS232C is standard, and there is an optional IEEE standard definition output.

This Unit operates at 2 different tape playback speeds, as follows:
HDCAM Tape Frequency: 1080/29.97 Hz: 96.7mm/s (PsF or Interlace source)
HDCAM Tape Frequency: 1080/25 Hz: 80.7mm/s (PsF or Interlace source)
Shuttle Mode is ±21X, Jog Mode is ±1X
Servo Lock is 1 Second or less (from Standby on)

JH1 connections
Analog HD video Output BNC (x 3) Y: 0.7 vp-p, Pb/Pr: +/-0.7vp-p 75 oHm (to 20Mhz Luma Y)
Analog HD video Output EIAJ RC-5237 connector, EIAJ CP-4120 standard
Computer display Output D-sub 15 pin, XGA Analog (1024 x 768 dots), RGB, 0.7 V
(R: 700 mV (±5 %), G: 700 mV (±5 %), B: 700 mV (±5 %) at 60Hz, H Frequency 48.4 kHz)
(Note: In this output, HD Image is letterboxed 1024x577 at picture center)
Audio monitoring Output Pin jack (x 2): -10 dBu at 47 koHms load, unbalanced
Audio monitoring Output XLR (mappable, male x 2) +4 dBm, 600 oHm load, low impedance, balanced
Headphone Output JM-60 stereo phone jack, - to -12 dBu at 8 oHms, unbalanced
RS-232C D-sub 9 pin male (x 1) (Supports optional JZ1 Sony Logging Software**)
Wireless remote BIRCS
EXT Sync Input BNC x 2 (HD TriLevel or SD BB or Composite Sync, frame locked)

JH1 Options
Optional: Power Cord
Tele-File Label system with JZ1 Option MLB-1M-100
Future Options may or may not be available.

Additional Notes
Output follows the playback frequency (but there is no tape playback of 24 frame Cine Alta, no slew of 25 to 24 or 25 to 23.98, and no pulldown mode).  Assemble or Insert editing functions can not be used to control the JH1 via the DV Link.

Any of these specifications may change without notice.  The JH1 does not have a TC output connection, nor does it have any digital HD SDI or SD SDI Video output, and it has no RS422 control capability.  V-ANC output is not supported.  Additional limitations may apply.

Standard Accessories
Operation manual (CD-ROM), Quick operation guide, Vertical stand (x 2), Infra-red remote controller.  Power Cord is not included. Any of these specifications may change without notice.